cylinder-water-sparkling-6.html
Exclusive manual EN_SE_DK_NO_FI
7 / 44
7 removing the gas cylinder. place the sparkling
water
maker on a flat surface and remove the back section by pressing the button on the back and then pushing the back section first up and then out. unscrew the cylinder, at which point the sparkling
water
maker will tip forwards slightly. tilt the sparkling
water
maker a little further forwards and lift out the cylinder. filling the
water
bottle
. clean the
bottle
before
use
. do not
use
water
hotter than 40 o c. fill the
bottle
with cold
water
up to the maximum volume mark. if the
bottle
is overfilled,
water
can enter the machine and leak out. for best results,
use
cold
water
; the colder the
water
, the greater the volume of gas that can be dissolved. it is therefore a good idea to store an extra
bottle
of
water
in the fridge. make sure, however, not to keep the
water
for too long in the
bottle
as it might become stale. important! never carbonate anything other than pure drinking
water
, as sugar or other additives might ca
use
the pressure relief valves to stick, rendering the machine unsafe to
use
. gb
water-bottle-until-8.html
