content-pressure-hose-128.html
CW Product Cat UK
129 / 140
129 additional information flashback arrestor blue hose:
oxygen
hose fitting, right-hand thread lighting injector torch extinguishing injector torch 1. set the pressure 2. open the
oxygen
valve
3. open the fuel gas
valve
4. light the torch 1. close the fuel gas
valve
4. relieve the hose pressure 2. close the
oxygen
valve
5. relieve the load on the regulator 3. close the cylinder
valve
lighting and extinguishing pressure torch information. 1 + 4a 1 + 4a 1 + 4a 3 + 3b + 11a 7a 2 + 3a + 7b + 11b 2 + 3a + 7b + 11b 4 3 + 3b + 11a 3 + 3b + 11a 3 + 3b + 11a 8 + 9 5 1. set the working pressure on the cylinder regulators 3b. then close the
oxygen
valve
on the
cutting
attachment until only a little gas is flowing out 7a. press and hold the rocker arm for the
cutting
oxygen
11a. close the
oxygen
valve
on the
cutting
attachment 2. open the
oxygen
valve
on the handle fully 4. open the acetylene
valve
on the torch handle approximately half a turn 7b. adjust the flame with the
valve
on the
cutting
attachment until you have a clear core flame immediately after the
cutting
nozzle 11b. when you leave the equipment after completing work: also close the
oxygen
valve
on the handle 3. open the
oxygen
valve
on the
cutting
attachment and allow the
oxygen
to flow freely 4a. adjust the acetylene regulator until the cylinder reaches the required pressure, see the
cutting
table 8+9. release the rocker arm. the equipment is now ready for
cutting
. 3a. adjust the pressure on the
oxygen
regulator to the required level, see the
cutting
table. 5. light the flame (use gas lighter) 10. close the acetylene
valve
on the handle
gas-detectors-use-130.html
